upper motor mount

Discussion in 'General Motoring' started by p_vouers, Oct 12, 2005.

  1. p_vouers

    p_vouers Guest

    97 SL2
    The upper mount looks like it had been replaced but I can't really
    tell. I read that if you can get a finger in it, it needs to be
    replaced but that is confusing. The center is tight and I can hardly
    get the tip of my finger in but the sides(off center) I CAN get my
    finger in. Does this mean it is bad or maybe installed improperly if
    that is possible??

    Thanks
    Phil
     
    p_vouers, Oct 12, 2005
    #1
  2. p_vouers

    Blah Blah Guest

    Sounds good to me. Pop the hood and have someone hold the brake while in
    gear and throttle up and down "smoothly" while you watch the engine. Try
    to gage the amount of movement or bucking the engine does.

    ps: dont get run over
     
    Blah Blah, Oct 12, 2005
    #2
  3. p_vouers

    p_vouers Guest

    well I replaced the monut and MOST of the buzz is now gone. The old
    mount had a split the width of the mount all along the bottom.
     
    p_vouers, Oct 13, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 2000 SL1 Motor Mount

  2. New Motor Mount Installed - Car Is Like New

  3. Upper strut mounts all the same?

  4. Lower motor mount replacement?

  5. replacing motor mount w/ after market parts - is it ok?

  6. motor mount threads stripped?

  7. Motor Mount Problem

  8. Motor mount or transmission? regarding a Saturn SW2 1993 wagon

Loading...