SC2 rear windshield seal

Discussion in 'General Motoring' started by marx404, Aug 29, 2005.

  1. marx404

    marx404 Guest

    I have installed XM radio in my '02 SC2. I mounted the tiny magnetic antenna
    on the back of the roof in the center, the wire which is less than a 1/8 "
    is running out from under that seal on the top of the back windshield.

    I am concerned that I might get water in there and that someting inside
    behind that seal or around the windshiels (like clips, or the body) will
    rust eventually.

    Some tell me dont worry, the seal is superficial, some say I should fill the
    small area where that XM wire raises the seal to prevent internal rust, who
    should I believe?

    Please help, I am very concerned and in rainy season here in FL. Do I need
    to worry about plugging up that gap or do I leave it alone? Thanx.

    marx404
     
    marx404, Aug 29, 2005
    #1
  2. marx404

    news Guest

    No dont worry, your Saturn will have a catastrophic motor failure like a
    cracked block, piston seizure or timing chain breakage at speed, long
    before you need to worry about anything rusting...

    Next time....buy an AMERICAN car... LOL
     
    news, Aug 30, 2005
    #2
  3. marx404

    marx404 Guest

    er, shouldn't you be posting your thoughts at alt.uninformed.trolls ? Saturn
    is made and built in America. Thanx fer playing anyway, go troll somewhere
    else please.

    marx404
     
    marx404, Aug 30, 2005
    #3
  4. marx404

    news Guest

    It's called cynicism, but apparently the concept is a reach for some. My
    apologies. Trust me- if I wanted to troll these apparently rich waters I'de
    use a three mile long purse seine instead of a fly rod, and go way over
    federal quotas...

    Some Toyota's are more "American-made" than some Saturns. That is, unless
    you equate "assembled in... (pick a state) with real manufacturing?

    No, I'm not a Toyota fan.
     
    news, Aug 31, 2005
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.